Sharp SD-AT1000W Spécifications télécharger pdf (Page 209)

Maxiva UAX

October 17, 2013

5‐29

888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.

Figure 5-17 FWD cable to REV port with 20dB pad

Note

The RFLD Sample cable is removed, and the FWD sample cable is connected to the REV input through a

20dB attenuator pad.

If an attenuator pad was originally present on the REV input, it should also be

moved along with the REV sample cable)

IfanattenuatorpadwasoriginallypresentontheFWDinput,shouldbemov ed alongwiththeFWDsamplecabletothe

REVinput.The20dBattenuatorpadcalledoutinthisprocedurewouldbeinadditiontoanyattenuatorpadalready

presentontheFWD samplecable.

Note

REV (reverse) and RFLD (reflected) are used here synonymously.

STEP 14 HighPointCalibration:Removethe20dBattenuatorpadusedintheprevious

stepandconnecttheFWDsamplecabledirectlytotheREVinput.PressSave

tostorethevalue.RefertoFigure5‐18onpage5‐30.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 291 292

Pas de commentaire

Sharp SD-AT1000W Spécifications Page 209