Sharp IQ-8000 Manuel d'installation télécharger pdf (Page 124)

10.4 Resetting the IQ-400E

If the IQ-400E panel is accidentally set to an incorrect (and/or unknown) IP address, it is possible to

reset the panel to its original default IP address.

1. Power off the IQ-400E board.

2. Reset SW1 DIPswitch to (11101110)

3. Power up the board. The IQ-400E board LED Array will initially show 8.8., then 8.6., then

8.8. once again –board is now reset. The board reset has created the following default

values:

a. Logon is “admin”

b. Password is “PYMTF”

c. “Host IP” is reset to ‘0’

d. “Our IP” is reset to 192.168.168.32

3. Using your Internet browser, type in the IP address 192.168.168.32. The IQ LAN module

should be in default mode.

NOTE Your computer’s TCP/IP has to be set to the 192.168.168.xxx for proper

communication to the panel.

4. See page 104, steps 5 through 8, for proper resetting of the TCP/IP configuration for the

board.

NOTE When reset, the LAN module will default to Panel 1 and the default address.

Page cxi of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 119 120 121 122 123 124 125

Pas de commentaire

Sharp IQ-8000 Manuel d'installation Page 124