Sharp IQ-8000 Manuel d'installation Page 24
- Page / 125
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
4.0 Wiring Your Readers
4.1 Grounding Your Readers
PCSC has designed its products to withstand most inductive voltage spikes without effect.
However, some noise found in power supplies and door strikes, in addition to static discharge,
may cause the control unit to momentarily shut down, lockup, or in extreme cases, to become
damaged. Unexplained lockups and intermittent system behavior are common symptoms of static
or noise problems. If cycling power will remedy your problem, carefully follow these instructions:
1. Install MOVs (Metal Oxide Varistors, Siemens S10K30 or the equivalent) or reversed biased
diodes (1N4004 - 1N4007) at each Door Strike. When installed, they will suppress most
problem Door Strikes.
2. Readers should be properly earth-grounded for uninterrupted reads. Please be aware that
operation is affected by the amount of static present during certain times of the year.
3. Properly grounding all readers and hardware, in addition to suppressing noise in the
peripheral equipment, should allow for many problem free years of use with PCSC products.
4. In addition, PCSC recommends using a separate filtered, electronically regulated output,
switchable power supply for door strikes.
5. Before installing the reader, please read the following instructions. Damage may occur if this
is disregarded.
6. Installation must meet all local, state, and federal regulations and codes for electrical
installation. If these codes conflict with the installation methods described in this manual,
please call your service representative.
4.2 Properly Routing Your Cables
Do not route data and power cables in the same conduit. Crosstalk and transmission of electrical
noise may result. The IQ-400 PCB’s will become damaged if the power cable grounds to the data
cable.
NOTE: High Voltage and Low Voltage wiring must be routed separately and
maintain a minimum spacing of 0.25 inches.
Page xi of 110 IQ-400 Installation Manual 33-10057-001-C
- Installation Manual 1
- 33-10057-001 1
- 0.1 Board Diagrams 3
- 0.1.4 OUT Expansion Board 6
- 0.1.5 ALM Expansion Board 7
- 0.1.6 SAM Board 8
- 0.2 Table of Contents 9
- 1.0 Introduction 14
- 2.0 Unpacking the IQ-400 16
- IQ-400 - Expansion Cable Plug 19
- 3.0 Installing Power 20
- 4.0 Wiring Your Readers 24
- 4.3.1 Procedure 25
- 4.4.1 Procedure 28
- 4.4.2.1 Procedure 28
- 5.0 Reader Connections 29
- Option 1 34
- Option 2 35
- – Option 2 37
- IQ-400 Board 38
- Expansion Board 39
- 6.0 Wiring the Door(s) 46
- 6.6.3 SAM Board LED Arrays 56
- Exit Sense Inputs 59
- 6.10.1 Procedure 61
- 7.1 Reset the IQ-400 Panel 62
- 7.5 Changing the Baud Rate 69
- PCSC P/N: 04-10318-101 73
- PCSC P/N: 04-10318-001 73
- HyperTerminal 76
- Protocol) 77
- 7.10.2 Installation 78
- 7.10.3 Optical Transmission 80
- 8.1 Status Lights 81
- 8.2 Communication Errors 82
- 8.2.2 Error Codes 83
- (Pins 2-3) 86
- 8.8 User Selectable Options 91
- 8.9 Point Definitions 93
- 8.9.1 Sense Inputs 93
- S3 through S6 are 94
- IQ 4 PCB 94
- 8.9.2 Outputs 96
- Connector 96
- 9.1 IQ-400 Features 99
- 9.1.3 Spare Parts- IQ-400 PCB 100
- 9.2.1 Electrical Ratings 101
- 9.2.2 Power Supply 101
- 9.2.3 Door Sense LEDs 102
- 9.2.5 Jumpers 102
- 9.3.2 System Capacities 104
- 9.3.3 Electrical Ratings 104
- 9.4.1 Electrical Ratings 106
- 9.4.2 Power Supply 106
- 9.4.3 Door Sense LEDs 107
- 9.4.5 Jumpers 107
- 9.5.1 System Capacities 109
- 9.5.2 Electrical Ratings 109
- 9.6.1 System Capacities 111
- 9.6.2 Electrical Ratings 111
- 9.6.3 Spare Parts- OUT PCB 111
- 9.7.1 System Capacities 112
- 9.7.2 Electrical Ratings 112
- 9.8 SAM Board 113
- 4-wire PCSC 114
- 5-wire Wiegand 114
- 9.10 Tool Requirements 115
- 10.1.1 Required Equipment: 118
- 10.1.2 Required Information: 118
- 10.1.3 Required firmware: 118
- 10.3.1 TCP/IP Configuration 121
- 10.4 Resetting the IQ-400E 124
- End of Manual 125
- PCSC, Inc 125
- August 2008 125
Produits connexes et manuels pour Composants des dispositifs de sécurité Sharp IQ-8000
(14 pages)Origin Storage TS-L840D manuals
Owner’s manuals and user’s guides for Unknown Origin Storage TS-L840D.
We providing 1 pdf manuals Origin Storage TS-L840D for download free by document types: Datasheet
Commentaires sur ces manuels