Sharp ER-A330 Manuel d'utilisateur télécharger pdf (Page 29)

2. Flash report

REPORT NAME KEY ENTRY

MODE

DATA FOR READING REMARK

OP X/Z X1/Z1 X2/Z2

XZX1Z1

X2 Z2

NET3

TL/NS

DEPT

DPTn

DPT# DEPT. CODE

DEPT/GROUP

CR1 GROUP CODE 7

HOURLY

#/TM/ST TIME 8

CID

⊗

7 To read respective reports, it is necessary to follow the proce-

dure below.

8 To read respective reports, it is necessary to follow the proce-

dure below.

3. Overflow mark

If the amount in any totalizer other than GT to be printed on X or Z

reports exceeds a programmed limit, the indication mark (overflow

mark) is printed for the totalizer concerned.

The overflow mark may be printed even if a totalizer does not reach

the maximum amount. This occurs, for example, when the amount in

the totalizer gets smaller than the maximum amount due to the entry

of a negative amount after the overflowing of the totalizer. This

means that when the totalizer overflows once, the overflow mark (for

example, "★★★") is printed.

Samples of respective reports are shown on the following pages.

Group No. CR1

TIME : 24 hour system (2 digits)

TIME #/TM/ST

DEPT#

Dept. code

– 28 –

1 2 ... 24 25 26 27 28 29

Pas de commentaire

Sharp ER-A330 Manuel d'utilisateur Page 29