Sharp AL-1000 Series Spécifications télécharger pdf (Page 40)

Appendix

MOVING INSTRUCTIONS

When moving this copier, follow the procedure below.

When moving this copier, be sure to remove the TD cartridge in advance.

Turn the power switch off and disconnect the power cord.

q Open the side cover while pressing the side cover open button. w Push gently

on both sides of the front cover to open the cover.

Gently pull the TD cartridge out while pressing the lock release button. See page

26, TD CARTRIDGE REPLACEMENT.

Close the front cover and then the side cover by pressing the round projections near

the side cover open buttton.

When closing the covers, be sure to close the front cover securely and then

close the side cover. If the covers are closed in the wrong order, the covers

may be damaged.

Raise the handle of the paper tray and pull the paper tray out until it stops.

Push the center of the pressure plate down until it locks in place and lock the plate

using the pressure plate lock which has been stored in the front of the paper tray.

Use a coin (or suitable object) to attach to the left side of the copier the screw that

has been stored in the front of the paper tray.

When shipping the copier, the screw must be reinstalled to prevent shipping

damage.

Push the paper tray back into the copier.

Close the paper output tray extension, and attach the packing materials and tape

which were removed during installation of the copier. See page 11, REMOVING

PROTECTIVE PACKING MATERIALS.

Pack the copier into the carton. See page 10, CHECKING PACKED COMPONENTS

AND ACCESSORIES.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47

Pas de commentaire

Sharp AL-1000 Series Spécifications Page 40