Sharp TL-M5200 Spécifications télécharger pdf (Page 35)

-35

Multi Screen

Setting up the Multi Screen

Controlling

When you want to control the monitors collectively for the multi screen, connect LAN cables to the LAN

terminals and set both “TCP/IP” and “Master & Slave”.

Following is an example of how to use 4 monitors with a hub connection.

Info

• To set up the multi screen, assign a monitor as the master and the other monitor as the slave and connect

the monitors with commercially available LAN cables (UTP cable, Category 5, cross-over type). In this

way, you can control the both monitors with one remote control.

• The buttons below can control both the master and the slave at one time.

• ON button • AUTO SYNC button

• STANDBY button • RESIZE button

• DIRECT INPUT buttons • AV MODE button

(COMPUTER1, COMPUTER2, DVI, • FREEZE button

HDMI, S-VIDEO, VIDEO) • P&P button

• AV MUTE button • SELECT button

• VOLUME buttons

• In normal operation, the monitor set as the slave cannot be controlled by the remote control.

• Even while the monitor is set as the slave, the buttons on the monitor can be used.

Monitor 1 : Master

Monitor 3 : Slave

Monitor 2 : Slave

Monitor 4 : Slave

Computer

LAN cable

(cross-over type,

commercially available)

Hub

LAN terminal LAN terminal

LAN cable

(straight-through type,

commercially available)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Pas de commentaire

Sharp TL-M5200 Spécifications Page 35