Sharp TL-M5200 Spécifications télécharger pdf (Page 11)

-11

Setting up the Monitor Network Environment

1. Connecting the Moni-

tor to a Computer

Establishing a one-to-one connection from the

monitor to a computer. Using a LAN cable (Cat-

egory 5, cross-over type) you can configure

the monitor via the computer.

1 Disconnect the computer’s LAN

cable from the existing network.

2 Connect a LAN cable (a UTP

cable, Category 5, cross-over

type) to the monitor’s LAN ter-

minal and connect the other end

of the cable to the computer’s

LAN terminal.

3 Plug the power cord into the AC

socket of the monitor.

4 Turn on the computer.

Info

Confirm that the LINK LED on the rear of the

monitor illuminates. If the LINK LED does not

illuminate, check the following :

• The LAN cable is properly connected.

• The power switches of both the monitor and

the computer are on.

LAN cable

(cross-over type, commercially available)

A LAN cable being

connected to the network

This completes the connection. Now proceed to “2. Setting an IP Address for the

Computer”.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Pas de commentaire

Sharp TL-M5200 Spécifications Page 11