Sharp 25R S100 Manuel d'utilisateur télécharger pdf (Page 36)

36

1 2 3

4 5 6

7 8 9

0

100

POWER

TV

DVD

VCR

MENU MUTE

PAUSE

FLASHBACK

DISPLAY

INPUT

STOP REC

REW PLAY FF

CH/SKIP

VOL

—

CH

CH

VOL

+

ENTER

A B C D

PERSONAL PREFERENCE

CATV TV

DVD VCR

Operation of Remote Control (Continued)

L HOW TO IDENTIFY A VCR

The remote control may already be set to

operate your VCR. Try this initial check to see

if going on to the following “identify” section is

necessary.

(1) Slide

CATV/DVD-TV/VCR

switch to VCR.

(2) Point remote towards VCR and press

DVD/

VCR

POWER

.

(3) Does the remote turn the VCR ON and OFF?

• If yes, the remote is ready to operate the VCR

and no further steps are needed.

• If no, continue to the “identify” section.

L To Identify Your VCR – Direct Entry Method.

Use the following steps and list to quickly find

the remote control code for your accessory

VCR.

• First look up your VCR’s remote control code

number before going through the direct code

entry steps control.

• If this procedure does not identify your

accessory VCR, use the Search method of

identification (described in the next section).

(1) Slide

CATV/DVD-TV/VCR

switch to VCR.

(2) Press and hold down

DISPLAY

and

CH DOWN

(

9

)

on your remote control.

Then release both buttons.

(3) Within ten seconds after releasing

DISPLAY

and

CH DOWN (

9

)

, enter your VCR’s two-

digit remote control code number using

REMOTE KEYPAD

(refer to list).

• The remote control is now ready to send

commands to your VCR.

Some brands have more than one remote

code listed, due to changes in the remote

codes from early to later model years, or due

to format differences (VHS/BETA). In such

cases, you may have to try more than one code

to find the code your VCR accepts.

Note:

Depending on the model, year produced,

brand, and type of VCR, some models may

not be compatible with the remote control.

L To Identify Your VCR – Search Method.

(1) Slide

CATV/DVD-TV/VCR

switch on the

remote to VCR.

(2) Press POWER on the VCR to ON.

(3) Stand at least six feet away from the front of

the VCR.

Point the remote towards the VCR.

Hold down

DISPLAY

and

CH UP (

8

)

at the

same time. KEEP HOLDING THE BUTTONS

DOWN.

(4) Watch the Channel Number indicator on the

VCR, Channel numbers will scan up when the

VCR has been identified.

Release

DISPLAY

and

CH UP (

8

)

as soon

as the channel numbers start to scan up.

The VCR’s remote control code number has

been identified, and the remote is ready to

operate the VCR.

DVD/VCR

POWER

DISPLAY

CHANNEL

UP (8)/

DOWN (9)

CATV/DVD-TV/VCR

REMOTE

KEYPAD

TV

POWER

35-39 25R-S100.p65e 19/1/01, 4:40 PM36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire