Sharp R-201T Manuel d'instructions télécharger pdf (Page 25)

MS 201 T

English

If the groove is not at least this deep:

N Replace guide bar

Otherwise the drive links will grind

against the base of the groove – the

bottoms of the cutters and the tie straps

will not lie against the bar.

If there is a noticeable loss of engine

power:

N Turn cap 90° to the left

N Lift off the shroud

N Lift off the air filter

N Wash the filter with STIHL special-

purpose cleaner (special

accessories) or a clean, non-

flammable cleaning liquid (e.g.,

warm soapy water) and dry it

Do not clean fleece filters (depending on

version) with a brush.

Always replace a damaged filter.

Exhaust emissions are controlled by the

design of the fundamental engine

parameters and components (e.g.

carburation, ignition, timing and valve or

port timing) without the addition of any

major hardware.

Chain type Chain pitch Minimum

groove depth

Picco 1/4“ P 4.0 mm

Rapid 1/4“ 4.0 mm

Picco 3/8“ P 5.0 mm

Rapid 3/8“; 0.325“ 6.0 mm

Rapid 0.404“ 7.0 mm

Cleaning the Air Filter

0012BA012 KN

0012BA013 KN

Engine Management

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Pas de commentaire

Sharp R-201T Manuel d'instructions Page 25