Sharp R-202M Manuel de l'opérateur télécharger pdf (Page 37)

Great Plains Mfg., Inc. Table of Contents ► Section 4: Operating and Maintenance

1/10/2005 Series VII 6113-6328 Field Cultivator, Rigid Hitch 560-202M

drag easier by changing the angle of the

first row of teeth. Always make sure that

the drag is never pulling off the hang

chains. If so, shorten pull chains.

b.) On coil tine drags, start with the top

eyebolt (12) centered. Then level drag

mainframe (4R and 4L) by changing

position of leveling bolt (21). There are

two holes in the arm and four in the

mainframe. One of these will get you

where you need to be to level. To lay the

teeth back, remove the clip pin (42) on

each end and move strap adjustment by

pushing the handle (7) forward. This strap

has 5 holes and will let you lay the teeth

back several degrees. If it is desired to set

one row, usually the first, different than the

rest as far as the angle is concerned, it can

be adjusted individually by loosening the

U-bolt and set- screw on each end of the

drag bar. Down pressure on the drag is

achieved by lengthening the eyebolt (12)

on the top bracket. Depending on the

amount of down pressure, you may need

to relieve the mainframe.

c.) If a basket is added, adjust the amount of

down pressure by either shortening the

eyebolt for less pressure or lengthening

the eyebolt for more pressure.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Pas de commentaire

Sharp R-202M Manuel de l'opérateur Page 37