Sharp R-880S Manuel de l'opérateur télécharger pdf (Page 51)

Unit Operation

CAUTION: The motor may start automatically any time the

unit is turned on.

When the motor is preparing to start, the SR-3 Standard Truck

HMI Control Panel will continue to show the Standard Display

as shown in Figure 28. The preheat buzzer at the unit (located

on the unit Interface Board) sounds for 20 seconds before the

electric motor starts.

Figure 28: Standard Display

Switching from Diesel to Electric

IMPORTANT: Applies to units with the Electric Standby

Option only. The operation of this feature can be changed

using the Guarded Access Menu. See the Guarded Access /

Unit Configuration Menu / Diesel to Electric Auto Switch

Enabled feature in Section 3 of this manual for details. The

Diesel to Electric Auto Switch Enabled feature should be set

YES on units equipped with the Standard Truck HMI Control

panel.

Diesel to Electric Auto Switch Enabled set YES

(Default): If this feature is set YES, the unit will switch

automatically from Diesel Mode to Electric Mode when

standby power is connected and present.

Diesel to Electric Auto Switch Enabled set NO: The

Diesel to Electric Auto Switch Enabled feature should not be

set NO on units equipped with the Standard Truck HMI

Control panel.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 110 111

Pas de commentaire

Sharp R-880S Manuel de l'opérateur Page 51