Sharp Actius PC-RD20 Spécifications télécharger pdf (Page 17)

Removal and Disassembly

16 MAINTENANCE MANUAL

4. If necessary, remove the output shaft and

the bearing cones as an assembly from the

output bearing cage.

A. Place the output shaft and the output bear-

ing cage in a press. Figure 3.13.

B. Press the output shaft and cones bearing

cage.

C. Remove the outer cup from the output shaft.

5. Use a press or a bearing puller to remove

the bearing cones from the output shaft.

See the procedure in section 3.

Removal Bearing Cones the Output Shaft

Press Method

1. Place a used bearing cup on the inner bear-

ing cone

2. Place the output shaft into a press. Figure

3.14. The used bearing cup supports the out-

put shaft.

NOTE:

When you press the output shaft from the

cage, the bearing cup remains in the cage.

The outer cup is removed with the thru-shaft

and the cones.

Figure 3.13

Figure 3.14

PRESS

USED BEARING

CUP

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 119 120

Pas de commentaire

Sharp Actius PC-RD20 Spécifications Page 17