Sharp Actius PC-RD20 Spécifications télécharger pdf (Page 15)

Removal and Disassembly

14 MAINTENANCE MANUAL

5. Remove the output shaft bearing cage cap-

screws and washers.

6. Pull the bearing cage, bearings and shaft as-

sembly from the axle housing. If necessary,

loosen the cage from the housing with a soft

mallet. Figure 3.8

Removal differential assembly from the

Axle Housing

1.Place a hydraulic jack under the differential

assembly to support the assembly. Figure 3.9.

2. Remove all but the top two differential to housing

capscrews or stud nuts and washers. Figure 3.9.

3. Loosen, but do not remove, the top two dif-

ferential to housing fasteners. The fasteners

will hold the diferrential in the axle housing.

4. Loosen the differential assembly in the axle

housing. Use a plastic mallet to hit the differ-

entialmountingangeatseveralpoints.

5. After the differential is loosened, remove the

top two stud nuts and washers that hold the

assembly in the axle housing.

Figure 3.7

Figure 3.8

Figure 3.9

REMOVING THE

FLANGE

REMOVING

THE YOKE

HIDRAULIC

JACK

TOP TWO FAS-

TENERS

OUTPUT SHAFT AND DE BEARING

CAGE ASSEMBLY

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 119 120

Pas de commentaire

Sharp Actius PC-RD20 Spécifications Page 15