Sharp PGC30XU Instructions d'exploitation télécharger pdf (Page 17)

E-16

Operation

Basic Operations

1 Make the necessary connections before pro-

ceeding. Connect the power cord to a wall outlet.

The POWER indicator lights up red and the

projector enters standby mode.

• If the bottom filter cover is not securely installed, the

POWER indicator flashes.

2 Press Power ON.

• The flashing green LAMP REPLACEMENT indicator shows

that the lamp is warming up. Wait until the indicator stops

flashing before operating the projector.

• If the power is turned off and then immediately turned on

again, it may take a short while before the lamp turns on.

• If the keylock level is set to “Level A” or “Level B”, Power

ON and Power OFF can only be used on the remote

control. (See page 41.)

• After the projector is unpacked and turned on for the first

time, a slight odor may be emitted from the exhaust vent.

This odor will soon disappear with use.

When the power is on, the LAMP REPLACEMENT

indicator lights indicating the status of the lamp.

Green: Lamp is ready.

Flashing green: Warming up.

Red: Change the lamp.

PG-C30XU/CD (E)-c 00.5.19, 3:46 PM16

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Pas de commentaire

Sharp PGC30XU Instructions d'exploitation Page 17