Sharp FO-DC600 Manuel d'instructions Page 74

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 220
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 73
Introduction
72
Steps required for setup
The following steps are necessary to use the network scanner option. The
steps must be completed in the order shown.
1. Your dealer must install the FO-LN1 network interface kit and the FO-NS2
network scanner kit, and enter the network scanner product key. The machine
must be connected to the network.
2. The IP address of the machine must be set as explained on page 73.
3. E-mail server and DNS server settings must be configured in the Web page
in the machine. This is done from a Web browser on a computer connected to
the same network as explained on page 77.
4. Scan to E-mail setup must be completed as explained on page 82.
5. To use Scan to Desktop, you must install the Network Scanner Tool and
Sharpdesk programs in your computer. These programs are installed from the
CD-ROM that comes with the network scanner kit (see page 94 for installation
instructions). Users guides in PDF format for the programs are also included
on the CD-ROM.
6. Destinations for Scan to E-mail and Scan to FTP can be programmed into
Rapid Key and Speed Dial numbers using the Web page in the machine.
These procedures are explained on page 79.
Scan to E-mail destinations can
also be programmed using the operation panel of the machine as explained
on page 87. To use a Rapid Key or Speed Dial number to transmit a scanned
document, see pages 87 and 89. To transmit a scanned document to an e-
mail address without using a Rapid Key or Speed Dial number, see page 85.
all.bookPage72Wednesday,December18,20028:17AM
Vue de la page 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 219 220

Commentaires sur ces manuels

Pas de commentaire