Sharp AR-FX11 Spécifications Page 111
- Page / 120
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
109
KEY OPERATOR PROGRAMS
8
POLLING SECURITY
These settings are used for the public box for regular
polling memory. Note that they do not apply to F-code
polling memory. (See "USING POLLING MEMORY"
page 41.)
POLLING SECURITY
When performing polling memory (see "Polling
security" on page 43), this setting is used to select
whether any machine will be allowed to poll your
machine, or only machines that have been
programmed in your machine. Normally this setting is
enabled.
1
Follow steps 1 through 6 of "INITIAL
PROCEDURE" (page 96).
2
Select "POLLING SECURITY" with the [ ]
or [ ] key and then press the [OK] key.
3
Select "POLLING SECURITY" with the [ ]
or [ ] key and then press the [OK] key.
• The setting is enabled and a checkmark appears in
the checkbox.
• If this procedure is performed when the setting is
enabled, the checkmark will be cleared and the
setting disabled.
POLLING PASSCODE # MODE
When "POLLING SECURITY" is enabled, use this
setting to program (or delete) the fax numbers of the
machines that are allowed to poll your machine.
Programmed fax numbers are called passcodes. Up to
10 fax numbers can be programmed. To check the
programmed numbers, print the "KEY OPE. LIST"
(page 97).
1
Follow steps 1 through 6 of "INITIAL
PROCEDURE" (page 96).
2
Select "POLLING SECURITY" with the [ ]
or [ ] key and then press the [OK] key.
3
Select "POLLING PASSCODE # MODE"
with the [ ] or [ ] key and then press the
[OK] key.
4
Select "ENTER" with the [ ] or [ ] key
and then press the [OK] key.
5
Enter a 2-digit control number from 01 to 10
with the numeric keys to identify the
passcode that will be entered in the next
step, and then press the [OK] key.
If you make a mistake, move the cursor to the mistake
with the [ ] or [ ] keys and enter the correct number.
6
Enter the passcode number (up to 20
digits) and then press the [OK] key.
If you make a mistake, press the [C] key and then
re-enter the correct number.
To clear a passcode number, follow these
steps:
(1) Select "DELETE" in step 4 and then
press the [OK] key.
(2) Enter the control number that identifies
the number you wish to clear, and then
press the [OK] key.
(3) Select "DELETE" with the [ ] or [ ]
key and then press the [OK] key.
Note
Pegasus-E_Fax_Sec.book 109 ページ ２００４年９月２４日 金曜日 午後２時５１分
- CAUTION: 2
- WARNING: 2
- INTRODUCTION 3
- CONNECTING AN EXTENSION PHONE 3
- CONTENTS 4
- CONVENIENT METHODS OF USE 5
- PROGRAMMING 5
- TROUBLESHOOTING 5
- KEY OPERATOR PROGRAMS 5
- A FACSIMILE 6
- Lithium battery 7
- Please note 7
- FCC NOTICE TO USERS 8
- IMPORTANT SAFETY INFORMATION 9
- NOTICE FOR USERS IN CANADA 10
- BEFORE USING THE FAX 11
- FUNCTION 11
- PART NAMES AND FUNCTIONS 12
- (2) (3) (4) (5) (6) (7) (8) 13
- FAX MODE (BASE SCREEN) 14
- AUDITING MODE 15
- ORIGINALS 16
- PLACING THE ORIGINAL 17
- Stand-by. 100% 18
- MAY 10 MON 10:25 AM 18
- MEMORY AUTO 18
- CONT 8 x11R 18
- STANDARD 18
- V W XYZ SP 20
- U V W XYZ 20
- BASIC OPERATIONS 21
- SENDING A FAX 22
- Using the SPF 23
- Using the document glass 23
- REDIAL/PAUSE SPEED 24
- COMM. SETTING 24
- 26 27 28 29 30 25
- 31 32 33 34 35 25
- 36 37 38 39 40 25
- Booklet Tablet 26
- Faxing by direct transmission 27
- ENTER DIAL # 28
- MANUAL AUTO 28
- Quick On-line 29
- Image rotation 29
- CANCELING A FAX TRANSMISSION 30
- FAX STATUS 31
- RECEIVING FAXES 32
- Enabling fax print hold 34
- ADVANCED TRANSMISSION 36
- ENTER RX STATION 37
- AUTOMATIC TRANSMISSION AT A 38
- SPECIFIED TIME 38
- Press the [OK] key 39
- Polling memory 40
- 26 27 28 29 41
- 31 32 33 34 41
- Serial polling 42
- READ-END 44
- Direction of 46
- FAXING A DIVIDED ORIGINAL 47
- A FAX TRANSMISSION 48
- T DUPLEX 49
- FORWARDING RECEIVED FAXES TO 50
- NOT POSSIBLE 50
- TRANSMISSION USING 52
- F-CODE POLLING MEMORY 54
- USING F-CODE POLLING MEMORY 55
- TRANSMISSION) 59
- ACC. #-C 61
- F-CODE RELAY BROADCAST 62
- TRANSMISSION 62
- CONVENIENT METHODS OF 64
- W XYZ SP 65
- 47 48 49 50 67
- [F-code settings] 68
- [Chain Dialing] 69
- [Transmission speed setting] 70
- [Storing a group key] 71
- Editing a group key 73
- Deleting a group key 75
- [STORING A PROGRAM] 76
- [EDITING PROGRAMS] 77
- [DELETING PROGRAMS] 77
- PROGRAMMING, EDITING, AND 78
- DELETING F-CODE MEMORY BOXES 78
- MEMORY) BOXES] 81
- PRINTING LISTS OF PROGRAMMED 85
- INFORMATION, SETTINGS, AND 85
- COMMUNICATION ACTIVITY 85
- ENTERING CHARACTERS 86
- CHARACTER ENTRY KEYS 87
- (example: TPS) 88
- Entering symbols 88
- SPEC. CHARACTER 89
- 1/ 2 89
- ENTER NAME 89
- REPORT AT REGULAR INTERVALS 92
- WHEN AN ALARM SOUNDS AND A 92
- WARNING MESSAGE IS DISPLAYED 92
- SELF-DIAGNOSTIC FUNCTION 93
- PROBLEMS AND SOLUTIONS 94
- KEY OPERATOR PROGRAM MENU 97
- PROCEDURE FOR USING THE KEY 98
- OPERATOR PROGRAMS 98
- FAX FUNCTION 99
- INITIAL SETTING 100
- OWN PASSCODE SET 101
- SPEAKER VOLUME 101
- TX/RX END SOUND 101
- TX/RX END SOUND LENGTH 101
- EXTENSION TEL 101
- ACCOUNT CONTROL 102
- ACCOUNT # SET 102
- DISTINCTIVE RING 102
- REMOTE RECEPTION 102
- DATE & TIME SET 103
- DAYLIGHT SAVING TIME SETTING 103
- SENDING FUNCTION 104
- PAGE COUNTER SET 105
- SEND MODE 105
- QUICK ON LINE TX 105
- PRINT STATION # IN RCVD DATA 105
- ACC. NAME PRINT 105
- RECALL SETTING (BUSY) 106
- RECALL SET (ERR) 106
- RCV. FUNCTION 107
- #OF RINGS AT. RX 108
- TRAY SELECTION 108
- RECEIVED DATA PRINT CONDITION 108
- DUPLEX RECEPTION 109
- A3 RX REDUCE 109
- FW. RX DATA 109
- RECEIVED DATA FW. STATION SET 109
- INDEX PRINT 110
- EARLIER OUTPUT 110
- ANTI JUNK FAX 110
- ENTER JUNK FAX # 110
- POLLING SECURITY 111
- APPENDIX 112
- SHARP ELECTRONICS CORPORATION 120
Produits connexes et manuels pour Copieurs Sharp AR-FX11
Copieurs Sharp MX-B382 Spécifications
(56 pages)
(56 pages)
Copieurs Sharp AL-1651CS Manuel de service
(160 pages)
(160 pages)
Copieurs Sharp MX-2700G Spécifications
(88 pages)
(88 pages)
Copieurs Sharp AR-M208 Manuel d'utilisateur
(24 pages)
(24 pages)
Copieurs Sharp MX-M465N Manuel d'utilisateur
(28 pages)
(28 pages)
Copieurs Sharp AL-2061 Spécifications
(178 pages)
(178 pages)
Copieurs Sharp MX-M363N Spécifications
(113 pages)
(113 pages)
Copieurs Sharp AR-M162 Spécifications
(108 pages)
(108 pages)
Copieurs Sharp AR-5120 Spécifications
(66 pages)
(66 pages)
Copieurs Sharp MX-C380 Guide d'installation
(84 pages)
(84 pages)
Copieurs Sharp MX-M363U Manuel d'utilisateur
(12 pages)
(12 pages)
Copieurs Sharp AR-CF2 Manuel d'utilisateur
(12 pages)
(12 pages)
Copieurs Sharp MX-M282N Manuel d'utilisateur
(12 pages)
(12 pages)
Copieurs Sharp AR-5316E Spécifications
(19 pages)
(19 pages)
Copieurs Sharp AX-600X(R) Spécifications
(132 pages)
(132 pages)
Copieurs Sharp MX-4101N Guide d'installation
(45 pages)
(45 pages)
Copieurs Sharp MX-M362N Manuel d'utilisateur
(12 pages)
(12 pages)
AEG Electrolux EFP 60202 manuály
Uživatelské manuály a uživatelské příručky pro Odsavače par AEG Electrolux EFP 60202.
Poskytujeme 1 manuály pdf AEG Electrolux EFP 60202 ke stažení zdarma podle typů dokumentů: Specifikace
Aeg electrolux EFP 60202 Specifikace (17 strany)
Značka: Aeg-electrolux | Kategorie: Cooker hoods | Velikost: 0.50 MB |
Tabulka s obsahem
Další produkty a příručky pro Odsavače par AEG Electrolux
| Modely | Typ Dokumentu |
|---|---|
| DK 9090 |
Uživatelský manuál
  
DK 9990 - Amazon S3,
88 stránky
|
| CHDI 8610 |
Specifikace
AEG Electrolux CHDI 8610 Specifications,
20 stránky
|
| DF7290 |
Uživatelský manuál
 
DF7290 DF7190 - Vanden Borre,
76 stránky
|
| DD 8765 |
Uživatelský manuál
AEG Electrolux DD 8765 User manual,
72 stránky
|
| DD6690-M |
Uživatelský manuál
DD6660-M DD6690-M [en] ,
64 stránky
|
| DU 4360 |
Uživatelský manuál
 
DK 4390 DK 4360,
40 stránky
|
| DF7290 |
Uživatelský manuál
DF7190-M DF7290-M LIBRETTO ISTRUZIONI USER MANUAL [de] [es] [fr] [it] [nl] [pt] ,
40 stránky
|
| DD 8861 |
Specifikace
AEG Electrolux DD 8861 Specifications,
84 stránky
|
| FM2500DD-A |
Uživatelský manuál
Aeg-Electrolux FM2500DD-A Ohjekirja,
16 stránky
|
| DF7290-M |
Uživatelský manuál
Aeg-Electrolux DF7290-M Handleiding,
40 stránky
|
| 7509D-M |
Uživatelský manuál
Aeg-Electrolux 7509D-M User Manual [en] ,
20 stránky
|
| DK3360-M |
Uživatelský manuál
Aeg-Electrolux DK3360-M Handleiding,
36 stránky
|
| 7509D-M/A |
Uživatelský manuál
Aeg-Electrolux 7509D-M/A User Manual,
16 stránky
|
| X76263MK1 |
Uživatelský manuál
Aeg DD6660-M Manuali i perdoruesit,
96 stránky
|
| DI9993-M |
Uživatelský manuál
Aeg-Electrolux DI9993-M Handleiding [fr] ,
80 stránky
|
| DD9993-M |
Uživatelský manuál
Aeg-Electrolux DD9993-M Brugermanual,
76 stránky
|
| X67453MD0 |
Uživatelský manuál
Aeg-Electrolux X67453MD0 Manuali i perdoruesit,
96 stránky
|
| DD6690-M |
Uživatelský manuál
Aeg-Electrolux DD6690-M Handleiding [en] ,
64 stránky
|
| X99384MV0 |
Uživatelský manuál
Aeg-Electrolux X99384MV0 Brugermanual,
72 stránky
|
| DD9995-W |
Uživatelský manuál
Aeg-Electrolux DD9995-W Handleiding,
48 stránky
|
© 2020, manymanuals.fr. Tous droits réservés | 0.026 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels