Sharp AR-160 Spécifications télécharger pdf (Page 17)

BEFORE USING THE MACHINE

Loading the bypass tray

Unfold the bypass tray.

When feeding large

paper such as B4 and A3

(8-1/2" x 14" and 11" x

17"), pull out the bypass

tray extension.

Set the paper guides to the copy

paper width.

Insert the paper (print face down) all

the way into the bypass tray.

To prevent a misfeed,

verify once more that the

paper guides are

adjusted to the width of

the paper.

Important points when inserting paper in the bypass tray

• Up to 100 sheets of standard copy paper can be set in the bypass tray.

• Be sure to place A6, A5 or 5-1/2" x 8-1/2" size paper or envelopes horizontally as shown in the following diagram

().

• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction

flaps (not the closure flap).

• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a

time through the bypass tray.

• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then

reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.

• Do not use paper that is smaller than the original. This may cause smudges or unclean images.

• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause

smudges or unclean images.

If you loaded paper in the bypass tray, press

the [TRAY SELECT] key ( ) to select the

bypass tray. The bypass tray will not be

selected automatically.

Note

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 91 92

Pas de commentaire

Sharp AR-160 Spécifications Page 17