Sharp XE-A113 Manuel d'instructions télécharger pdf

Model XE-A113

Installing The Cash Register

Install the cash register using the fixing

angle bracket provided with the register.

• Thoroughly clean the location where the

fixing angle bracket (B) is to be placed.

• Peel off the adhesive tape on the fixing

angle bracket.

• Hook the angle bracket onto the hook

(A) that is located at the bottom rear of

the register.

• Firmly stick the fixing angle bracket to

the table surface that you cleaned above.

To remove the register from the fixing

angle bracket.

• Lift up the front of the register and pull

the register towards you.

Important Notice

The cash register will

operate correctly only

after the following steps

have been carried out:

For quick set-up, follow the instructions shown below. Note that malfunction may occur if

you do not follow the steps. For further information, please read the instruction manual.

Before setting up your cash register, prepare three new R6 or LR6 batteries ("AA" size),

which are necessary for memory backup, and find a stable surface near an AC outlet

where the cash register is not subject to water sources or direct sunlight.

PGM

MGROPX/Z

REG

X2/Z2

X1/Z1

Mode Lock

PGM

MGROPX/Z

REG

X2/Z2

X1/Z1

Mode Lock

Preparing The Cash Register

Initialising The Cash Register

To ensure the cash register operates correctly, initialize it using the following

procedure.

• Make sure the AC power cord is unplugged and batteries are not installed

in the register.

• Insert the manager (MA) key into the mode switch and turn to the REG position.

• Insert the plug of the AC power cord into the AC outlet. A buzzer will sound 3 times.

IMPORTANT: This operation must be performed without batteries installed.

• The register display should now show " 0.00".

NOTE: If the buzzer does not sound when the plug is inserted, the

initialization has not been done successfully. Wait at least one minute

after pulling out the plug, and insert the plug again.

Installing the Batteries

Install three new R6 or LR6 batteries ("AA" size) according to the procedure

shown below with the power cord connected and set the mode switch to

REG position.

• Lift the rear of the printer cover and detach it.

• Open the battery compartment cover.

• Install three new R6 or LR6 batteries ("AA"size) as per the diagram.

When the batteries are properly installed " " on the display will disappear.

• Close the battery compartment cover.

1 2 3 4

Résumé du contenu

Page 1 - Model XE-A113

Model XE-A113Model XE-A113Installing The Cash RegisterInstall the cash register using the fixing angle bracket provided with the register.• Thoroughl

Page 2 - Basic Programming

Install the Paper RollReceipt• Lift up the print roller release lever to unlock and open the print roller arm.• Set a paper roll in the paper roll

Page 3 - Programming A Department Name

PGMMGROPX/ZREGX2/Z2X1/Z1Mode LockEntering A Basic SaleInsert the operator key into the mode lock and turn to the REG position.The cash register has th

Page 4 - Reporting

PGMMGROPX/ZREGX2/Z2X1/Z1Mode LockProgramming A Receipt Message944123Insert the manager (MA) key into the Mode Lock and turn to the PGM position.For ex