Sharp ER-A320 Manuel d'utilisateur télécharger pdf (Page 24)

2. Flash report

REPORT NAME KEY ENTRY

MODE

DATA FOR READING REMARK

OP X/Z X1/Z1 X2/Z2

XZX1

NET3 CA/AT

DEPT

DPTn

DEPT. CODE

DPT#

DEPT/GROUP

MDSE SBTL

GROUP CODE

HOURLY

#/TM/SBTL

TIME

CID

@/FOR

To read respective reports, it is necessary to follow the procedure

below.

To read respective reports, it is necessary to foIIow the pro-

cedupe below.

To read respective reports, it is necessary to follow the procedure

below.

3. Overflow mark

If the amount in any totalizer other than GT to be printed on X or Z

reports exceeds a programmed limit, the indication mark (overflow

mark) is printed for the totalizer concerned.

The overflow mark may be printed even it a totalizer does not reach

the maximum amount. This occurs. for example, when the amount in

the totalizer gets smaller than the maximum amount due to the entry of

a negative amount after the overflowing of the totalizer. This means

that when the totalizer overflows once. the overllow mark (for example,

★★★") is printed.

TIME

TIME : 24 hour system (2 digits)

#/TM/SBTL

DEPT#

Dept. code

MDSE SBTLGroup No.

1 2 ... 19 20 21 22 23 24 25

Pas de commentaire

Sharp ER-A320 Manuel d'utilisateur Page 24