Sharp XV-Z9000E Spécifications télécharger pdf (Page 20)

Setup & Connections

Using the Adjustment Feet

Setting Up the Screen

You can adjust the height of the image by raising the projector with

the foot releases.

1 Press the foot releases and lift the projector to the desired angle.

2 Remove your hands from the foot releases. Once the adjustment

feet have locked in position, release the projector.

3 If the screen is at an angle, the adjusters can be used to adjust

the angle of the image.

Returning the projector to its original position

While holding the projector, press the foot releases and slowly lower

the projector to its original position.

CAUTION

• Do not hold the lens when lifting or lowering the projector.

• When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the

projector.

• The projector is adjustable up to approximately 5° from the standard position.

• When the height of the projector is adjusted, the image may become distorted (keystoned), depending on the relative

positions of the projector and the screen. See page 19 for details on the keystone correction.

The picture can be adjusted within the shift range of the lens by rotating the lens shift dial on the top of the

projector using your finger.

Using the Lens Shift

Lens shift dial

DOWN UP

Projector

Projected Image

DOWN

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 62 63

Pas de commentaire

Sharp XV-Z9000E Spécifications Page 20