Sharp AR-PG1 Spécifications télécharger pdf (Page 5)

13) Attach the SPF to the copier.

●

Attach the SPF by inserting the hinge guide sections of the SP3

into the hinge guides L and R.

14) Insert the power plug into the outlet and turn the main switch of

the copier to the “ON” position.

15) Perform SIM setting.

●

Execute simulation [2] of [26] and enter [1].

16) Check the ON/OFF operation of the open detection sensor and

book detection sensor.

●

Execute simulation [2] of [2] and check that the indicator on the

operation panel lights up and goes out by opening and closing

the SPF. When the book detection sensor is turned ON/OFF, the

drum replacement lamp is turned ON/OFF accordingly.

17) Check the copy ratio, and then check the center displacement and

leading edge image void.

●

Place an original on the document glass and make a copy.

Then, place an original in the document feeder tray and make a

copy.

If the center of the copy from the document glass is displaced

from the copyfrom the document feeder, adjust the center refer-

ring to the service manual.

2. AR-FX3 Installation Manual

Turn the main switch to the “OFF” position and remove the power plug

from the outlet.

1) Remove the document cover and the rear cabinet.

●

After removing the document cover, remove the four screws and

then remove the rear cabinet.

Circuit standard label, 1 sheet

AR-SP3

2 – 3

1 2 3 4 5 6 7 8 9 10 ... 46 47

Pas de commentaire

Sharp AR-PG1 Spécifications Page 5