Sharp AN-LS1 Spécifications télécharger pdf (Page 48)

Check the network settings for the computer and AN-LS1.

\ Check the following network settings for AN-LS1.

• IP address

\\ Check that the IP address for AN-LS1 is not duplicated on the network.

• Subnet mask

\\ When the gateway setting for AN-LS1 is “0.0.0.0” (Not Used), or the gateway setting for AN-

LS1 and the default gateway setting for the computer are the same:

•The subnet masks for AN-LS1 and the computer should be the same.

•The IP address parts shown by the subnet mask for AN-LS1 and the computer should be

the same.

(Example)

When the IP address is “192.168.150.2” and the subnet mask is “255.255.255.0” for AN-

LS1, the IP address for the computer should be “192.168.150.X” (X=3-254) and the subnet

mask should be “255.255.255.0”.

• Gateway

\\ When the gateway setting for AN-LS1 is “0.0.0.0” (Not Used), or the gateway setting for AN-

LS1 and the default gateway setting for the computer are the same:

•The subnets for AN-LS1 and the computer should be the same.

•The IP address parts shown by the subnet mask for AN-LS1 and the computer should be

the same.

(Example)

When the IP address is “192.168.150.2” and the subnet mask is “255.255.255.0” for AN-

LS1, the IP address for the computer should be “192.168.150.X” (X=3-254) and the subnet

mask should be “255.255.255.0”.

•The factory default setting of the network setting for AN-LS1

IP address : 192.168.150.2

Subnet mask : 255.255.255.0

Gateway address : 0.0.0.0 (Not Used)

•For network settings for AN-LS1, refer to page 18.

\ Take the following steps for checking the network settings for the computer.

1. Open a command prompt (MS-DOS Prompt).

•In the case of Windows 98 or 98SE: click “START” → “Programs” → “MS-DOS Prompt” in

order.

•In the case of Windows Me: click “START” → “Programs” → “Accessories” → “MS-DOS

Prompt” in order.

•In the case of Windows 2000: click “START” → “Programs” → “Accessories” → “Command

Prompt” in order.

•In the case of Windows XP: click “START” → “Programs” → “Accessories” → “Command

Prompt” in order.

2. After launching the command prompt (MS-DOS Prompt) enter a command “ipconfig”.

• Communication may not be established even after carrying out the network settings for the computer. In

such cases, restart your computer.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54

Pas de commentaire

Sharp AN-LS1 Spécifications Page 48