Sharp R-4A55 Manuel de l'opérateur télécharger pdf (Page 12)

1. If installed, remove nylon line head, upper xing plate, shield plate,

and plastic shield:

a. Align locking hole in upper plate with notch in edge of gear

housing and insert head locking tool (A).

b. Remove line head (B) by turning it clockwise until head is

completely off of shaft.

c. Remove locking tool.

d. Remove three screws holding shield plate and plastic shield

e. Retain line head, upper xing plate, shield plate, and plastic

shield for conversion back to nylon line head operation.

2. Align hole in upper plate (D) with notch in gear housing (E), and

insert locking tool to prevent splined shaft from turning. Arrow on

gear housing ange points to notch location.

3. Remove split pin (F), L.H. blade nut (G), lower plate (H), and up-

per plate (D) from PTO shaft. Turn blade nut clockwise to remove.

4. Remove locking tool.

5. Loosely attach bracket (I) to shield (J) and attach shield to bottom

of gear housing (E) with hardware provided.

6. Tighten all shield hardware.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Sharp R-4A55 Manuel de l'opérateur Page 12