Sharp PC-9800T Spécifications Page 46

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 125
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 45
2
Installing Units into Bays
When shipped, your notebook is equipped with the CD-ROM drive in the right-side
bay and with the floppy disk drive in the left-side bay. You can uninstall these
drives and install other units such as the battery pack and the AC adapter.
• After installing or uninstalling the floppy disk drive, change the
settings. See the end of this section.
• You can install the AC adapter only in the left-side bay.
• You can install the CD-ROM drive only in the right-side bay.
Right-side Bay
The right-side bay is installed with the CD-ROM drive when the notebook is
shipped. You can install the following units into the right-side bay.
•
Battery pack
•
Floppy disk drive
To uninstall the unit in the right-side bay:
1. Turn off the notebook.
2. Disconnect the AC adapter and all the peripheral devices.
3. Turn the notebook upside down on a flat place.
4. Slide the bay lock latch to the releasing position, and gently draw the unit out.
The bay lock latch
2
1
Figure 2-2. Uninstalling the unit in the right-side bay
To install the unit in the right-side bay:
1. Make sure the notebook is turned off and upside down.
Basic Operations 2-7
Vue de la page 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 124 125

Commentaires sur ces manuels

Pas de commentaire