Sharp AN-P12EX Spécifications télécharger pdf (Page 21)

-21

Setting up the Projector Network Environment

1. Connecting the Pro-

jector to a Computer

Establishing a one-to-one connection from the

projector to a computer. Using a commercially

available LAN cable (UTP cable, Category 5,

cross-over type) you can configure the pro-

jector via the computer.

1 Disconnect the computer’s LAN

cable from the existing network.

2 Connect a commercially avail-

able LAN cable (UTP cable, Cat-

egory 5,

cross-over type) to the

projector’s LAN terminal and

connect the other end of the

cable to the computer’s LAN ter-

minal.

3 Plug the power cord into the AC

socket of the projector.

4 Turn on the computer.

Info

Confirm that the LINK LED on the rear of the

projector illuminates. If the LINK LED does not

illuminate, check the following :

• The LAN cable is properly connected.

• The power switches of both the projector

and the computer are on.

LAN cable

A LAN cable being

connected to the network

This completes the connection. Now proceed to “2. Setting an IP Address for the Com-

puter”.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 58 59

Pas de commentaire

Sharp AN-P12EX Spécifications Page 21