Sharp XG-MB70X Guide de démarrage rapide télécharger pdf (Page 7)

-7

Setting up the Projector Network Environment

1. Connecting the Pro-

jector to a Computer

Establishing a one-to-one connection from the

projector to a computer. Using a LAN cable

(Category 5, cross-over type) you can config-

ure the projector via the computer.

1 Disconnect the computer’s LAN

cable from the existing network.

2 Connect a LAN cable (a UTP

cable, Category 5, cross-over

type) to the projector’s LAN ter-

minal and connect the other end

of the cable to the computer’s

LAN terminal.

3 Turn on the projector.

4 Turn on the Computer.

Info

Confirm that the LINK LED on the rear of the

projector illuminates. If the LINK LED does not

illuminate, check the following :

• The LAN cable is properly connected.

• The power switches of both the projector

and the computer are on.

LAN cable

(cross-over type, commercially available)

A LAN cable being

connected to the network

This completes the connection. Now proceed to “2. Setting an IP Address for the Com-

puter”.

XG-MB70X_E_P02_19.p65 04.8.6, 2:23 PM7

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Pas de commentaire

Sharp XG-MB70X Guide de démarrage rapide Page 7