Sharp AR-NB2 Guide d'installation télécharger pdf (Page 8)

- 8 -

CONNECTING TO A NETWORK

After the network expansion kit has been installed in the

machine, connect a LAN cable to the LAN connector of

the network expansion kit.

Use a network cable that is shielded.

CHECKING THE IP ADDRESS

To check the IP address of the machine, hold down the status button on the network expansion kit at

least 2 seconds to print out a Printer Setting List.

HOW TO RESET THE NETWORK EXPANSION KIT

To reset the network expansion kit, turn on the power while holding down the status button on the

network expansion kit. Continue to hold down the status button until a beep sounds.

Network scanner destination information and scanning settings will remain after the network

expansion kit is reset, however, the network settings and printer settings will revert to the factory

default settings.

Status button

Caution

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Pas de commentaire

Sharp AR-NB2 Guide d'installation Page 8