Sharp AR-163 Spécifications télécharger pdf (Page 45)

GENERAL INFORMATION

Setting the power save modes

The time that elapses before the copier enters a power save mode after any

operation is made can be set manually. This time is set with user program No.

2 for the preheat mode and user program No. 3 for the auto power shut-off

mode. For these settings, see page 36.

●

The copier will enter the preheat mode first and then the auto power

shut-off mode after a preset time has elapsed when no copier operation

has been made.

●

If conflicting settings are made with user programs No. 3 and No. 5, the

last program set will have priority.

Copying from the preheat mode

Make desired copier selections and press the START

( ) key using the normal copying procedure.

●

When any key input is made or any other copier operation is made, the

POWER SAVE ( ) indicator will start to blink.

●

When the START key is pressed, the START key ( ) indicator will

go out and copying will start within 10 seconds. The POWER SAVE

( ) indicator will go out when copying starts.

Copying from the auto power shut-off mode

Press the START ( ) key.

●

The copier will exit the auto power shut-off mode and the POWER

SAVE ( ) indicator will start to blink.

Make desired copier selections and press the START

( ) key using the normal copying procedure.

●

It will take approximately 35 seconds for the copier to start copying.

However, you can make desired settings and press the START ( )

key during warm-up. Copying will start after warm-up is finished.

Power save modes

POWER SAVE MODES

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 79 80

Pas de commentaire

Sharp AR-163 Spécifications Page 45