Sharp AR-160 Spécifications télécharger pdf (Page 65)

OPTIONAL EQUIPMENT

Erase

This copier has an edge erase mode and a centre erase mode.

●

Edge erase can be used to eliminate shadow lines around the edges of

copies caused when thick paper or a book is used as an original.

●

Centre erase can be used to eliminate the shadow produced by the bindings

of bound documents.

●

Edge + centre erase can be used to eliminate shadow lines around the edges

of copies and to eliminate the shadow at the centre of copies.

●

The erase width can be set from 0 to 20 mm in five steps using user

program No. 16. See page 36.

●

This feature cannot be used with the 2 in 1 or 4 in 1 feature.

Place the original on the original table and close the

platen cover.

●

If an optional single pass feeder (SPF) is installed, it can also be used

for this feature.

Press the ERASE key to select the desired erase mode.

●

To select the EDGE + CENTRE ERASE mode, press the ERASE

key until both the EDGE and CENTRE indicators light up.

Check the copy paper size.

●

If non-standard size paper or the bypass tray is used, the paper will be

regarded as A3 size paper and the erase area will not be proper if the

paper size is not A3.

●

If an optional paper feed unit is installed, use the TRAY SELECT

key to select the desired paper size.

ELECTRONIC SORTING KIT (AR-EB3)

A B

Centre erase

Edge + Centre erase

Edge erase

Electronic sorting kit (AR-EB3)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 81 82

Pas de commentaire

Sharp AR-160 Spécifications Page 65