Sharp WQ-700H Manuel du propriétaire télécharger pdf (Page 14)

A. Plug in the power supply.

B. Press the call button on the door camera.

C. Check and adjust doorbell volume.

D. Check and adjust the picture quality.

E. Listen to the door camera and adjust the speaker volume.

F. Adjust view angle of the door camera.

A. For door strike installation instructions please refer to page 11.

B. If there is an electric strike installed, activate the monitor by pressing

the call button from the door camera.

C. Once the unit is activated, press and hold the door release button

and open the door.

D. If the strike is operational, it should release the door when the button is

pressed.

E. This is a DC powered strike, so it will trigger, and open the strike for as

long as you are holding the button.

4.2. Door release test(optional)

4. HFX-700M KIT Test after installation

4.1. Basic function test

Main monitor

Door camera

Call button

Brightness tuner

Sharpness tuner

Bell Volume tuner

Speaker Volume tuner

Cut-off button

Intercom button

Monitoring button

Door release button

Installed and with a good line, the need to test the system.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Pas de commentaire

Sharp WQ-700H Manuel du propriétaire Page 14