Sharp ER-A5IN Manuel d'utilisateur

MODELUP-600UP-700(For "U" & "A" version)CHAPTER 1. REMOVING THE REAR COVER...1CHAP

2. REPLACING THE STANDARD DRAWERUNITInstall the standard drawer unit in the reverse order of removal.The drawer top has the following holes with which

CHAPTER 7. MCR UNIT : UP-E13MR1) Align the MCR sheet with the positioning line of the topcabinet .2) Mark 3 points of the asterisk mark on the MCR s

CHAPTER 8.POLE DISPLAY UNIT : UP-P16DP1) Remove the rear cover.2) Connect the display cable to the POLE connector .3) Fix the earth wire to the mai

1) Connect the external cables to the I/F board.<ER-A5RS>• Install the core (RC0RF6700BHZZ) to the cable with a band.NOTE: Install the ferrite c

CHAPTER 10.HAND SCANNER : ER-A6HS1CAUTION: Before installation, be sure to turn off the power.1) Remove the rear cover.2) Connect the scanner cable t

CHAPTER 12. IN-LINE CABLE1) Remove the rear cover.2) Connect the LAN cable to the LAN connector .3) Install the core to the LAN cable . NOTE: Inst

COPYRIGHT  2001 BY SHARP CORPORATIONAll rights reserved.Printed in Japan.No part of this publication may be reproduced,stored in a retrieval system,

INTRODUCTION : CONNECTION OVERVIEW1. OVERVIEW OF CONNECTIONS2. OPTIONAL DEVICES THAT CAN BE CONNECTED Standard port Option port (ER-A5RS, ER-01EF)Port

3. RS-232 connecting device cable wiringdiagram1. [Scale: Local Purchase]1) Data transmission format- 7bits ASCII code- Even parity- One stop bit- Rat

3. [Coin dispenser: cont.]Auxiliary command4. [Roll printer: by Epson]1) Data transmission- 8bits ASCII code- No start bit- Non parity- One stop bit-

4. LANBASIC SPECIFICATIONSTransmission system: 10 Base-TTransmission speed: 10Mbits/secTransmission distance: Segment length max. 100mTransmission cab

CHAPTER 1.REMOVING THE REAR COVERCAUTION: Before installation, be sure to turn off the power.1. REMOVING THE REAR COVER1) Remove the two screws .2) R

4) Slightly lift and slide the top cabinet, and remove the groundingwire .Note: Do not pull up the top cabinet unit the grounding wireand connector ca

CHAPTER 3.REMOVING THE LCD UNIT1. REMOVING THE LCD UNIT1) Remove the top cabinet from the bottom cabinet.2) Remove the LCD flat cable and the earth w

CHAPTER 4.REMOVING THE PRINTER UNIT1. REMOVING THE PRINTER UNIT<UP-600>1) Remove the top cabinet.2) Remove the two screws fixed on the printer