Sharp R1871T Manuel d'utilisateur télécharger pdf

2 WALL CONSTRUCTION

This Microwave Oven/Hood should be mounted against and sup-

ported by a flat vertical wall. The wall must be flat for proper

installation. If the wall is not flat, use spacers to fill in the gaps.

Wall construction should be a minimum of 2" x 4" wood studding

and

/8" or more thick dry wall or plaster/lath. The mounting sur-

faces must be capable of supporting weight of 110 pounds—the

oven and contents—AND the weight of all items which would nor-

mally be stored in the top cabinet above the unit.

The unit should be attached to a minimum of one 2" x 4" wall stud.

To find the location of the studs, one of the following methods may

be used:

Use a stud finder, a magnetic device which locates the nails in

the stud.

B. Use a hammer to tap lightly across the mounting surface to find

a solid sound. This will indicate stud location.

The center of the stud can be located by probing the wall with a

small nail to find the edges of the stud and then placing a mark

halfway between the edges. The center of any adjacent studs will

normally be 16" or 24" to either side of this mark.

NOTE: In the event that the unit will be unable to be supported by any stud, it will be necessary to use spe

cial care in the placement of the toggle bolts and top cabinet screws. See Wall Template for details. The top

cabinet should be tested to ensure it is securely attached to the wall. Place extra weight up to 110 pounds

inside the top cabinet to test the support.

OVER THE RANGE MICROWAVE OVEN/HOOD SYSTEM

NSTALLATION INSTRUCTIONS

lease read all instructions thoroughly before installing the Microwave Oven/Hood System. Two people are

recommended to install this product.

If a new electrical outlet is required, its installation should be completed by a qualified electrician before the

Microwave Oven/Hood is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2.

1 MOUNTING SPACE

This Microwave Oven/Hood requires a mounting space on a wall

as shown in Figure 1.

If the space between the wall cabinets is greater than 30-inches

(36-inches or 42-inches), a Filler Panel Kit may be used to fill the

gap between the Microwave Oven/Hood system and wall cabi-

nets. The Filler Panel Kit is sold as an optional accessory; each

kit contains two 3-inch panels. The Filler Panel Kit should be

installed before the Microwave Oven/Hood is installed.

For proper installation and servicing, a 2-inch space is necessary

between the top of the range backsplash and the bottom of the

Microwave Oven/Hood system.

30" or more

from cooking

surface

Backsplash

Figure 1

At least 2"

30"

5.5"

2"x 4" Wood Studs

3/8" Dry Wall

or Plaster/lath

Figure 2

16" or 24"

66" or

Résumé du contenu

Page 1 - NSTALLATION INSTRUCTIONS

2 WALL CONSTRUCTIONThis Microwave Oven/Hood should be mounted against and sup-ported by a flat vertical wall. The wall must be flat for properinstalla

Page 2 - 4 HOOD EXHAUST DUCT

3 ELECTRICAL GROUNDING INSTRUCTIONSThis appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-ing plug.

Page 3 - 7 PREPARATION OF THE OVEN

36 INSTALLATION HARDWAREThe INSTALLATION HARDWARE (items 1-7)packed with the oven should contain the following:ITEM NAME QUANTITY PART CODE1 Wood Scre

Page 4 - 9 VENTILATION SYSTEM

8 PREPARATION OF THE OVEN1. Rest the oven on its side as shown in Figure 7. Place portion (C)of the carton underneath to protect the outercase from be

Page 5

5Figure 11Wire BoxC. VERTICAL EXHAUST: Outside Ventilation1. Remove and save the 4 screws from the Fan Cover Bracket. Remove FanCover Bracket by slid

Page 6 - 10 OVEN INSTALLATION

610 OVEN INSTALLATIONTHIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTINGINSTRUCTIONS FOUND ON BOTH TEMPLATES.READ AND FOLLOW MOUN

Page 7 - Figure 23

4. Thread the power supply cord through the hole made in the bot-tom of the top cabinet.5. Hang the oven on the lower edge of the mounting plate. Rota

Page 8 - ACCESSORIES

8CHECK LIST FOR INSTALLATION1. Make sure the unit has been installed according to all of the Installation Instructions, the Top Template andWall Templ

Commentaires sur ces manuels

Pas de commentaire

Sharp R1871T Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fours Sharp R1871T. R-1870 | R-1871 | R-1872 | R-1874 | R Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Sharp R1871T