Sharp LC-32SH340E Spécifications télécharger pdf (Page 14)

English - 13 -

Connecting the LCD TV to a

For displaying your computer’s screen image on your

LCD TV, you can connect your computer to the TV set.

Power off both computer and display before making

any connections. Use 15-pin D-sub display cable to

connect a PC to the LCD TV. When the connection

is made, switch to PC source. See “Input selection”

section. Set the resolution that suits your viewing

requirements. Resolution information can be found

in the appendix parts.

PC Input

(back)

Side AV Input

PC VGA Cable

(Not supplied)

PC Audio Cable

(Not supplied)

Using Side AV Connectors

You can connect a range of optional equipment to

your LCD TV.

For connecting a camcorder, connect to the VIDEO •

IN socket and the AUDIO SOCKETS. For selecting

the related source, see the section “Input selection”

in the following parts.

To listen the TV sound from headphones, connect •

to the HEADPHONE jack of theTV.

Camera

AVCable

(notsupplied)

Headphone

Remote Control Handset

Inserting Batteries

Remove the battery cover located on the back of •

the handset by gently pulling backwards from the

indicated part.

Insert two • AAA/R3 or equivalent type batteries

inside. Observe the correct polarity (+/-) when

inserting batteries and replace the battery cover.

Note: Remove the battery from remote control

handset when it is not to be used for a long period.

Otherwise it can be damaged due to any leakage of

batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.

Switch the “• ” button on the bottom right hand

side under the screen to position “|” so the TV will

switch to standby mode. Then the standby LED

lights up.

To switch on the TV from standby mode either:•

Press the “•

” button, CH / CH or a numeric

button on the remote control.

Press the “•

” or +/- button on the TV.

The TV will then switch on.•

Note : If you switch on your TV via CH

/ CH buttons

on the remote control or on the TV set, the programme

that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV to Standby

To switch the TV to low power stand by press the

“

” button on the remote control or right hand side

of the TV.

Note: When the TV is switched to standby mode,

standby LED can blink to indicate that features such

as Standby Search, Over Air Download or Timer is

active.

To Switch the TV Off

Switch the “• ” button on the bottom right hand

side under the screen to position 2 as illustrated,

to isolate the TV from the mains, the LED will

go out.

If the TV will not be used for a long period i.e. •

holidays, then unplug the power cord from the

mains socket.

A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32883W_YPBPR_ROCKER_10073200_50190034.indd 13A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32883W_YPBPR_ROCKER_10073200_50190034.indd 13 24.06.2011 17:37:1624.06.2011 17:37:16

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Sharp LC-32SH340E Spécifications Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour TV LCD Sharp LC-32SH340E