Sharp AR-C160 Spécifications télécharger pdf (Page 30)

2-6

CHAPTER2

USING THE RADF

●

Duplex copying will not work when a non-standard

sized paper or 5-1/2" x 8-1/2" paper is used.

●

Image loss (max. 13/64" (5 mm)) can occur along the

leading edge of the copies. Image loss (max. 9/32"

(7mm)) can occur along the trailing edge of the

copies. Also image loss (max. 1/4" (6 mm) in total)

can occur along the other edges of the copies.

●

The RADF can handle a maximum of 50 originals of

5-1/2" x 8-1/2" to 8-1/2" x 11" sizes and 30 originals

of 8-1/2" x 14" to 11" x 17" sizes.

●

2-sided to 1-sided copying and 2-sided to 2-sided*

copying can be performed.

* For 2-sided to 2-sided copying, an optional duplex

module (AR-DU2) must be installed.

●

The originals must be set face up in the document

feeder tray.

●

Different size originals with the same width can be

placed in the document feeder tray and automatically

copied onto copy paper of their respective sizes.

The automatic copy ratio selection will not function in

this case.

This copier can be equipped with an optional reversing

automatic document feeder (RADF).

The RADF will handle multiple originals.

●

Before loading originals into the document feeder

tray, be sure to remove any staples or paper clips

from them.

●

Damaged or crumpled originals or originals which

have been folded may misfeed in the RADF or cause

incorrect size detection. It is recommended that these

be copied from the document glass and the copies be

used as original documents.

●

When feeding originals which have closely spaced

binding holes punched along an edge, place the

originals so that the punched edge is positioned to the

right or along the side guides.

●

Special originals such as transparency film and tracing

paper should not be fed from the RADF, but should be

placed on the document glass.

Stream feeding mode

If the stream feeding mode has been enabled using a key operator

program, the message “NEWLY PLACED ORIGINALS WILL BE FED

AND COPIED AUTOMATICALLY.” will appear and the original feed

indicator will continue to blink for approximately 5 seconds after

feeding of all originals is completed. While this message is displayed,

any new originals placed in the document feeder tray will be fed and

copied automatically.

★ KEY OPERATOR See page 24 of the KEY OPERATOR’S GUIDE

for information on setting the stream feeding mode.

MAKING COPIES Using the RADF

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 147 148

Commentaires sur ces manuels

Pas de commentaire

Sharp AR-C160 Spécifications Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Copieurs Sharp AR-C160