Sharp ER-87SL Manuel d'instructions télécharger pdf (Page 98)

Reading (X) and Resetting (Z)

of Sales Totals

• Use the reading function (X) when you need to take the reading of sales information entered

after the last resetting. You can take this reading any number of times. It does not affect the

POS terminal’s memory.

• Use the resetting function (Z) when you need to clear the POS terminal’s memory. Resetting

prints all sales information and clears the entire memory except for the GT1 through GT3, reset

count, and consecutive number.

• X1 and Z1 reports show daily sales information. You can take these reports in the X1/Z1 mode.

• X2 and Z2 reports show periodic (monthly) consolidation information. You can take these

reports in the X2/Z2 mode.

• If your POS terminal is set “X1/Z1 report in the X2/Z2 mode” is “ENABLE,” you can select the

X1/Z1 report from the X2/Z2 mode. For details, contact your authorized SHARP dealer.

How to take a X1/Z1 or X2/Z2 report

[To take a X1 or X2 report:]

By selecting an item from the menu

1. Select “1 READING” in the X1/Z1 or X2/Z2 mode menu window to display the items list.

2. Select an item listed in the table shown later.

3. If needed, enter corresponding values described in the “Data to be entered” column on the table

shown later.

4. Select a device (“DISPLAY” or “REPORT PRINTER”) to receive the output.

By entering a job code

1. Enter a job code listed in the table shown later and press the

key in the X1/Z1 or X2/Z2 mode

menu window.

2. If needed, enter corresponding values described in the “Data to be entered” column on the table

shown later.

3. Select a device (“DISPLAY” or “REPORT PRINTER”) to receive the output.

[To take a Z1 or Z2 report:]

By selecting an item from the menu

1. Select “2 RESETTING” in the X1/Z1 or X2/Z2 mode menu window to display the items list.

2. Select an item listed in the table shown later.

3. If needed, enter corresponding values described in the “Data to be entered” column on the table

shown later.

4. Select a device (“DISPLAY” or “REPORT PRINTER”) to receive the output.

5. After the report has been taken, the message “ARE YOU SURE ?” will appear.

Select one of the following actions:

• Select “YES” to reset the sales information.

• Select “NO” to save the sales information.

XXX

X1/Z1 MODE

X2/Z2 MODE

OPXZ MODE

~ER-A750(SEEG)-7 97.3.31 3:43 PM Page 94

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 234 235

Commentaires sur ces manuels

Pas de commentaire

Sharp ER-87SL Manuel d'instructions Page 98

Commentaires sur ces manuels

Produits connexes et manuels pour Caisses enregistreuses Sharp ER-87SL