Sharp SD-AT1000 Spécifications télécharger pdf (Page 19)

E-18

SD-AT1000W_LAG_E3.fm04/7/9

SD-AT1000W

ENGLISH

TINSZA121AWZZ

Preparation for Use

- Setting the clock -

Setting the clock

By setting the unit to the correct time, you can use it not only as a clock but also for

timer playback.

You can set the clock even when the unit is in the stand-by mode.

In this example, the clock is set for the 24-hour (0:00) display.

To confirm the time display:

Press the CLOCK button.

The time display will appear for about 5 seconds.

Note:

The "ADJUST" or time will flash at the push of the CLOCK button when the AC power

supply is restored after a power failure or unplugging the unit.

Readjust the clock as follows.

To readjust the clock:

Perform "Setting the clock" from step 1. If the "ADJUST" is not flashing in step 1, step

2 (for selecting the 24-hour or 12-hour display) will be skipped.

To change the 24-hour or 12-hour display:

Press the CLOCK button and within 5 seconds, press the ENTER

button.

Press the or button to select the 24-hour or 12-hour display and

then press the ENTER button.

Note that this can only be set when the unit is first installed or it has been reset

(see page 31).

"12:00 AM" The 12-hour display will appear. (AM 12:00 - PM 11:59)

"AM 0:00" The 12-hour display will appear. (AM 0:00 - PM 11:59)

"0:00" The 24-hour display will appear. (0:00 - 23:59)

Press the or button to adjust the

hour and then press the ENTER but-

ton.

! Press the or button once to advance the time by 1 hour. Hold it down to

advance continuously.

! When the 12-hour display is selected, "AM" will change automatically to "PM".

Press the or button to adjust the

minutes and then press the ENTER

button.

! Press the or button once to advance the time by 1 minute. Hold it down

to advance continuously.

! The hour will not advance even if minutes advance from "59" to "00".

! The clock starts from "0" second (seconds are not displayed).

! The time disappears after approx. 5 seconds.

1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on

page 31 for details.]

2 Perform "Setting the clock" from the beginning.

SD-AT1000W(LAG) TINSZA121AWZZ

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Sharp SD-AT1000 Spécifications Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Sharp SD-AT1000